| Compool.pm |
NONE
The basic control packet allows the third party controller to
- Toggle On/Off state of the Spa, Pool, Aux 1 - 7.
- Enable or disable the Spa side remote(s).
- Cancel any current circuit delays (not recommended).
- Change/select heat source/method for Spa or Pool.
- Change/set desired temperature for Spa and/or Pool.
- Control Dimmers, (if unit has dimmers installed).
- Change/set the current time of day in LX3xxx control units clock.The basic acknowledge packet allows the third party to determine
- Current state of Spa, Pool, Aux 1 - 7.
- Current state of Heater and Solar for both Spa and Pool.
- Whether LX3xxx is in Service mode (no commands should be sent).
- Current state of Spa side remotes (enabled or not).
- Current heat source selection.
- Solar presence.
- Freeze protection mode.
- Current water and solar temperature for Spa and Pool.
- Desired/set temperature for Spa and Pool.
- Air Temperature (Freeze sensor, not intended offer an accurate )
(air temperature )
- Status of temperature sensors.
- Current time of day stored in LX3xxx unit.NONE
Compool_serial_port=COM2
bsobel@vipmail.com May 16, 2000
NONE
This program is free software; you can redistribute it and/or modify it under the terms of the GNU General Public License as published by the Free Software Foundation; either version 2 of the License, or (at your option) any later version.
This program is distributed in the hope that it will be useful, but WITHOUT ANY WARRANTY; without even the implied warranty of MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the GNU General Public License for more details.
You should have received a copy of the GNU General Public License along with this program; if not, write to the Free Software Foundation, Inc., 51 Franklin Street, Fifth Floor, Boston, MA 02110-1301, USA.
| Compool.pm |